• G.hn Coax MDU Ethernet Endpoint

    Model : CES–832 / CES–831

    Coax MDU Ethernet Endpoint
    With In-Building Coax
    Last Meters Distribution
    Providing a Managed
    1Gbps / 750Mbps
    High Speed Data

    Triple Play by QoS and IPv6 Support
    No additional network wiring …
    The Most Powerful Coax MDU Solution with Remote Management and Auto Provision.

    Introduction

    THE COAX MDU ENDPOINT, CES-832/831, IS THE BROADBAND ACCESS DEVICE OVER THE EXISTING COAXIAL CABLE.

    NO ADDITIONAL NETWORK WIRING IS NECESSARY. CABLE OPERATORS MAY JUST USE THE EXISTING COAX WIRING OF CABLE OPERATORS OR IN THE MDU BUILDING, THEN BE READY TO PROVIDE THE BROADBAND TRIPLE-PLAY SERVICES TO SUBSCRIBERS..

    LOW INITIAL DEPLOYMENT COST. THE LOW INITIAL COST CAN EXPAND THE SERVICE TO SMALL SCALE BUILDING WITH HIGHER SPEED THAN CMTS. DUAL SUPPORT OF IPV4 AND IPV6 PROVIDE THE FLEXIBILITY FOR OPERATORS.

    WITH HIGH THROUGHPUT AND QOS, IT CAN OPTIMIZE TRIPLE PLAY SERVICES.

    AUTO PROVISIONING AND REMOTE MANAGEMENT. IT MINIMIZES THE INSTALLATION AND SUPPORT COST.

    THE UNIQUE ENDPOINT SERVICE CONTROL SUPPORTS SERVICE PROVIDERS WITH DIFFERENT SERVICE LEVELS AND SERVICE SCHEMES.

    Features

    • Design for Operators Providing High Speed Data over Coax Network
    • EoC up to 1Gbps/750Mbps PHY/Throughput Rate as Distribution Backbone over Coax
    • Up to 80dB Attenuation on Coax Network
    • Two 10/100/1000M Gigabit Ethernet Ports
    • Ethernet Loop Detection and Isolation
    • Filter Built-in to Eliminate Noise from TV
    • QoS Priority and Mapping Support
    • Tag VLAN Configuration
    • Service and Bandwidth Control
    • IGMP Snooping Control